Find a local console repairer in West Melbourne

Hot water taps have become too tight. 3 in total.

Reattach and cement a roof cap that has been temporarily attached by silicone and cement cracks in the neighbouring few cap tiles. I have few replacement cap tiles in case you need to break the old one to remove it.

I need to have a mdf board cut into strips. 8 pieces total. Board is 9mm Panel Standard 2400 x 1200mm. Need 2 x 111.5cm, 2 x 13cm, 4 x 135cm. All 10cm wide. I will draw out the measurements on the board.

Ps5 needs power supply replacement asap

Nbn hardwired outside, needs cable to be run approximately 8 meters behind plasterboard to upstairs. Position nbn modem upstairs

Need help updating bathroom cabinets. Recently updated the kitchen cabinets and benchtop and need to match that with the bathrooms. See below for measurements for both bathroom cabinets and current photos of the bathroom cabinets and kitchen cabinets. Benchtop - x cm (TBC) Cabinet Doors - x cm (TBC) Cabinet height - x cm (TBC) Cabinet depth - x cm (TBC)

Replace cartridges and or seal of mixer taps . One in shower and another in Sink

supply and install 3 clipsal smoke alarms electric hardwired with battery backup. any other reputed brand will also be ok as long as it has warranty

We have purchased two new taps and just need the new ones connected and the old ones disconnected.

Looking for a professional to hardwire install Solid GPS tracker in a Ford Mustang 2018.

Need someone to Patch up small holes in wall asap. Photos as follows Shoot me your price.

I need 5 tap washers changed in suburb of manor lakes.

Move Standing desk pack (150cm) upstairs and assemble

Replace faulty shower taps with new ones. I have already purchased the new set

I need to replace my bathroom sink and taps. 🚰 I’ve purchased the new tap, the new sink and all the fittings. It will be going from a double tap sink to a single tap sink.

Few dents in the walls need to patch up and paint the photos is just for examplesonly could be more dents/ holes., front artificial grass is bit tidy up, hanging 5 frames they are not heavy, cupboards doors 2 need to aligned, 3 mirrors need to hang on the wall and fixing a towel holder in the powder room. It must be done tomorrow. Please read carefully. Thank you. Cost pet hour and you must be time efficient and know all the work to do.

2 x leaks 1. Shower in ensuit room, can not turn off, turned the knob tight but still leaking or running 2. Washing machine tap, when ever we turn cold water on it leaks from tap - Due date: Needs to be done on Monday, 5 February 2024

I have an unusual party game which is 240V called Mega Wire. Uncommon, but uncomplicated. It transforms into 12volt, where a thin cable/wire runs through the metal frame top, to set off the digital alarm - loser- if the players hand held ring touches the metal course as it travels along. (In the old days there were ones with little electric shocks!) I have to explain, so you can see what my issue is. The 2 ends where the curvy course is inserted (black), have a little 'end of the wire' inside, that protrudes into the black insert. This wire touches the inserted curvy metal course. This gives the 12v power to work the game. Someone damaged it a little, where the little wire has moved a little...the connection is not being made. I can feel the wire when I stick my finger down the hole. I have had it apart myself some time ago, when it was damaged. (You can see a pic where the wires were PULLED right OUT of the chrome pole!! What?! But thats not an issue now. Also see the WIRE in the pic where the black insert was broken in 2 at one time. My arthritic fingers prevent me from attempting this 'wire repositioning' myself, but its do-able. (This part been fixed 3 times before! This thing still owes me money! lol. An electrician would be the best perhaps, but I dont think its necessary in this case. The wire either makes a connection or it doesnt....sitting correctly. A good fix-it person is fine. (The last 2 wire fix-its were done by an acquaintance - an architect.) If you fail at doing what needs to be done, I will not review badly. Just need a LOCAL guy to have a bit of a look. If, after some examination, you dont think you can do it for some reason, we can stop there, settle the agreed bill here....at least I had a go......it's not the norm but its not rocket science either. (Maybe a mates rates rental for you can be an extra reward ;-) - Due date: Flexible

I have 3 fairly old taps which need new washers. I attempted the job myself but the taps are very tightly screwed and required a larger toolkit to unscrew, hence why I'm seeking some assistance. I will supply the washers. - Due date: Flexible

Remove Bird of paradise stumps/roots Two plants - Due date: Flexible