Find an experienced builder in Thornbury

We need wire installed on our existing aluminium pergola so that we can grow a grape vine on it for shade. - Due date: Before Saturday, 30 December 2023

Colour bond garden shed - Due date: Flexible

There is a block of what I think is reinforced concrete, dimensions approx 40 x 40x 150cm out the front of my unit. I'd like it demolished, removed and recycled. Access to the concrete is clear. - Due date: Flexible

Previous owners had cut a hole in the driveway concrete which we would like refilled. Dig out hole as needed, gravel to level, re-concrete and paint. Hole is approx 1.5x1m. See photos. - Due date: Flexible

Handyman needed for the following: - Assemble and install flat pack shed - Remove existing smaller shed - Angle grind clothesline After completion, the handyman can keep the clothesline and original shed (which is brand new). Otherwise we’ll sell them. The new shed is from Easy Shed and measures 3.75x1.5x2.12m. It comes with floor brackets and will need to sit atop concrete pavers (see pic). Instructions are included. - Due date: Needs to be done on Saturday, 8 July 2023

My house is freezing! Looking for someone to help find where all the cold air is coming in. Seal doors and windows. Put protectant on windows, set timers on heaters. - Due date: Flexible

Have some water damage in three rooms. Need a scope of works with a cost breakdown for each section of work. Need an initial site inspection but bulk of work can be done offsite. Only three rooms are affected. - Due date: Needs to be done on Monday, 28 November 2022

Assembly of easy shed narrow slider shed (https://easyshed.com.au/collections/sliding-door-sheds/products/narrow-slider-garden-shed-3m-w-x-0-78m-d-classic?variant=40701903044767) Iinstruction booklet attached and there are videos online on website above. Concrete slab already laid, ready for shed from Wednesday 16th. - Due date: Before Monday, 21 November 2022

Looking for someone to lay a rebated concrete slab (specification document attached) and assemble a steel shed (https://easyshed.com.au/collections/garden-sheds/products/narrow-slider-garden-shed-3m-w-x-0-78m-d-classic) - Due date: Flexible

I need someone with a wheelbarrow to come and move 2 cubic metres of veggie bed soil mix from a big pile in the driveway, down a path and over a lawn (about 50m) and into a raised veggie bed. The bed is 750cm high, so it will require lifting or reshovelling back out of wheelbarrow. - Due date: Needs to be done on Friday, 9 September 2022

Assemble a Stratco gable home shed 5.5m x 4m one roller door - Due date: Flexible

As disccused on previous task.

Assembly of the following shed and affixed to a paved/brick driveway. https://easyshed.com.au/products/flat-roof-garden-shed-2-25m-w-x-0-78m-d-classic With these https://easyshed.com.au/products/concrete-fixings

I have ordered an Absco Garden Shed (double door) 3.00mW x 1.52mD x 1.95mH and would like to have it installed. Paving is soon to be installed in our yard and the paving installers are also adding a 3.15m x 1.57m concrete slab in the backyard for the shed. The shed will need assembly and anchoring to the slab. It would be preferable if this could be done before end of January.

residential house full demolition. Need to supply demolition permit. Got a few other houses to demolish in other suburbs for the right contractor.

Assembly a bunnings shed 3x2

Looking for someone to install this Absco Regent shed on an existing concrete slab https://www.bunnings.com.au/absco-sheds-2-26-x-1-44-x-2-00m-grey-regent-single-door-garden-shed_p0269371?store=6308&gclid=Cj0KCQjw8eOLBhC1ARIsAOzx5cGZaY7NbvBbjJI--tt73QYAAvuG3lJZOp3Jbmz3qgFqDPuMZ6MQCTYaArNXEALw_wcB&gclsrc=aw.ds

Hi guys, just checking if anyone has capacity and skills to build a small enclosed garage attached to an existing house and against our neighbours brick garage. Attached is a photo which shows the space. We'll need a new foundation, rollerdoor and tin roof. Will need help and advice with permits, drainage and all that's required.

Hi, I need architectural drawings created of my proposed apartment renovation ready for my submission to the Council and to provide to the builder. I have previous floor structural drawings, a site plan and I can create a current floor plan (used to be draftsperson). My renovation looks at transforming the large bathroom into an additional room, complete with a backdoor where the existing window is, then creating a new bathroom within my internal space. This will require a few non-loadbearing walls to be removed, and additional plumbing to be placed within the current concrete slab. At this point, require those initial plans so I can get the planning process underway. ** Not sure if you will need to view or it can be done online - so, I am leaving that up to your discretion. Look forward to hearing from you. :}

Hi guys, We are just doing a simple kitchen Reno. It's in an old house extension. In a wall cavity there is a couple of studs, which I initially thought weren't baring any load. Now that we have removed the surrounds, we want to be sure and have a pro look at it, give it the go ahead to remove or maybe install a lintel. As you can see from the pics, it's old hardwood. But there isn't a lot above the wall, ie: reasonable flat corrigated iron. Should be pretty straight forward. Cheers