Find a local floorboard profesional in QLD

I have the skirting boards. They need to be installed. Glue and nails tools required

Full sand and stain required for our original hard wooden floorboards. We have renovated our house and kitchen floor had vinyl so there’s glue and marks to be removed. Cabinets and kitchen will be complete by end of May, so 10th June start date would be good. Realise in person quote will be required prior to starting job.

Skirting board need to put back we’re taken off while we got ikea Woodrow intall .

Skirting board needs to be replaced, can provide paint. Original skirting board is missing will have to be new

Large hole across two floorboards needs repair. Replace small section of floor with good boards taken from the closet floor. Needs to be flush with the existing floor so avoid needing to sand and recoat. Can use other scrap wood to replace the area inside the closet.

Laying hybrid flooring

Need i think they are floating floor boards replaced I have the floor boards

Collection of around 4-6 timber hybrid floorboards that have been damaged/scratched. We have replacement floorboards, and just need someone to fit them.

Install new skirting as floors have been redone . Also remove some old skirting to some areas looking for a plain skirting.

Looking for someone to install skirting boards in one room. 5 x 5.5 m room. We have the skirting boards and glue. Happy to purchase anything else that is needed. They will still need to be cut to size.

Installation of composite floorboards. Room size: 6.8m x 4.5m.

I would like to get 7.5 meters of skirting board cut into different pieces and nailed to the wall. The skirting board has a thickness of 11mm. I don’t have the nails and other equipments.

Looking for a carpenter to remove and replace existing floor skirting boards with new skirts. The new skirts are taller than the existing ones so aiming to have it looking nice once the work is done with minimal damage to existing walls. We will supply the new skirting boards (photo attached, already painted). Just need you to supply tools and consumables (nails, sealant, etc) Looking for someone to do a neat and tidy job who takes pride in their work. See floor plan photo, all 3 bedrooms + hallway + living room need the new skirts. Bathroom, toilet and kitchen dont need work. Also allow to seal between top of skirts and wall. Ideally if you can dispose of the old skirts that would be great, but if not you can move them downstairs and we will take to the tip another day.

Have the spare boards, the tiles under fridge are water damaged and need replacing

Floating Hybrid floor board needs replacing. The board originally lifted at the lip over time and then was recently chipped by a vacuum. Will need it to be removed and replaced. I have 4 spare floor boards. It isn't very close to a wall so was thinking of the alternative: removing one of the edge tongues of the new board then glueing it down (if possible). Thanks

I removed an internal wall, I now have bare timber that needs to be coated & polished to match the existing timber.

The room (~4x3m) has a chipboard cladding over the VJs. I would like the chipboard removed please. It is nailed in and fairly easy to remove by just pulling (no glue that we can see so far) however it pulls through the nails. The skirting boards and some trim will have to be removed as well as well as the nails. Rubbish can be left behind, we're happy to clean it all up.

I’m replacing skirting boards in one room of the house. Boards will be cut to size already, only installation required. - Due date: Needs to be done on Thursday, 8 February 2024

Remove and Replace approximately 32 metres of skirting board in garage. Seal any gaps. - Due date: Flexible

LAY FLOORBOARDS IN OPEN LIVING AREA AND 3 BEDROOMS. 3X3, 3.6X3,3X2.8,4X2.8,3.2X2.8 - Due date: Needs to be done on Tuesday, 12 December 2023