Find an experienced handyman in Darwin

Need an electrician to earth pool and surrounding fencing.

Removing taps from the bathroom and kitchen then replace with new ones

Spomeone to secure the board under my bed that holds the wooden slats up. A couple of nails/screws should do it.

I need my Absco Single Door Garden Shed to be built (1.52 x 0.78 x 1.95m).

Put up A dart cabinet on my back yard wall

Need a good job done to fix up door frame of house im moving to

Remove existing base plate. Cut, drill and weld new base plate.

This fly screen needs to be fixed by the 15th

Any sparkys can you help. I have my 2nd fridge outside usually works perfect. Suddenly the other day it started tripping half the power points in the house. Unsure why its happening. Not sure if its worth fixing. Any advise or offers will be considered.

- fixing fence - fixing boulders - fixing hezchem sign - painting arrow sign on driveway - fixing sign board

We have had 1% of our compressions locks fail. We are looking at putting a anti rattle lock on the trailer to be able to ensure the tailgate stays closed even if the compression lock fails. We are doing this as a precautionary measure for our customers. Photos below of the lock to install. I will be sending a kit of parts required get this work completed. Please feel free to reach out if you have any questions.

Fit new door and door handle

Hi, I’d like to get this skirt made before the 18th of May if possible. I can supply materials as I already have them :)

Hello I need someone to install a floating shelf in my room

2 x shelves to be put up. All I need is 10 holes to be drilled into cement wall. Each shelf needs 5 screws, hence 10 x drilling holes required. I tried to do it myself but I didn't have enough strength to drill very far into the cement. I have hammer drill and all bits required.

Remove few old wooden showroom panels from a wall without damaging the walls

There’s a hole in the screen door from the previous owners dog door but my new one needs to be attached with screws, drilled in through the wire screen door. The dog door fits into the current hole, so no cutting is needed but drilling screws into the wire door was an issue for my drill and we couldnt do it. The job will need the right tools or drill bit. - Due date: Flexible

I need the metal turntable attached to this round shelf unit to use as a spice rack. However, the turntable needs to rise above the feet on the bottom of the unit - there are 3 feet about 2.3cm thick and the centre foot where the upper shelves screw into. So it needs a round 2.5cm piece in between the bottom of the base and the metal turntable to lift the feet off the table surface. It will need to be a circular piece with a hole in the middle to accomodate the centre foot. - Due date: Before Sunday, 4 February 2024

Both these holes have been caused by using a strong adhesive which i wasn't aware would rip the paint. One is about 10 X 6 cm and the either about 6 X 4 cm. The larger one appears to be over wallpaper and the smaller one appears to be paint over wall. Would you help repair these? - Due date: Flexible

Drill into place our bicycle rack using masonry drill kit. - Due date: Before Friday, December 15, 2023